NETW 310 Final Exam New 2016

1. (TCO 1) Block encoding takes several _____ and sends them out as a new code word. (Points : 5) lecture/pg

2. (TCO 1) One hundred Mbps Ethernet uses _____ line signaling. (Points : 5)

3. (TCO 1) Manchester encoding is considered to be inefficent in its use of bandwidth because _____. (Points : 5)

4. (TCO 1) How many of the eight wires in a UTP cable do 1000Base-T systems use? (Points : 5) chapter 10

5. (TCO 2) The horizontal link cable consists of _____. (Points : 5)

6. (TCO 2) Plenum-rated cable has a code of _____ on it. (Points : 5)

7. (TCO 2) When terminating cable, you must use plugs and jacks rated to the _____ of cable you are using. (Points : 5) lecture

8. (TCO 2) Common core sizes for multimode fiber-optic cables are _____ and _____ microns. (Points : 5) book

9. (TCO 3) The TIA-569 standard covers _____. (Points : 5)

10. (TCO 3) The basic component of the 568 standard is the _____. (Points : 5)

11. (TCO 3) The TIA-606 standard covers _____. (Points : 5)

12. (TCO 3) Equipment and patch cables used in telecommunications closets are limited to _____. (Points : 5) week 3 lecture

13. (TCO 4) The outside plant is defined as _____. (Points : 5)

14. (TCO 4) The outside plant is typically routed into the building through the _____. (Points : 5) week 3 lecture

15. (TCO 4) The best choice for outside plant cabling is _____. (Points : 5)

16. (TCO 4) In general, a lightning protection system should _____. (Points : 5)

17. (TCO 5) The current form of Ethernet operation is _____. (Points : 5)

18. (TCO 5) The type field in an Ethernet II frame is _____ bytes long. (Points : 5)

19. (TCO 5) 0x means the number is a _____ number. (Points : 5)

20. (TCO 5) An Ethernet II frame always has this to delineate the start of the frame _____. (Points : 5)

21. (TCO 6) What part of the frame contains the error detection mechanism? (Points : 5)

22. (TCO 6) A bad NIC will cause frames to be _____. (Points : 5)

23. (TCO 6) The result of the checksum calculation is stored as a _____. (Points : 5)

24. (TCO 6) If the checksum calculated at both ends of a link does not match the frame, it is _____. (Points : 5)

25. (TCO 7) When troubleshooting at Layer 1, the first step is to _____. (Points : 5)

26. (TCO 7) Traffic on an Ethernet network tends to be _____. (Points : 5)

27. (TCO 7) What is SNMP? (Points : 5)

28. (TCO 7) Ping is used to _____. (Points : 5)